HVAC Oracle
KEYWORDS:
PART #:  
Home  |  Contact Us  |  Ask the Oracle  |  Parts  |  Service  |  Equipment  |  VIEW Cart  


Parts Depot HEATING

Name *
Response Email *
Work Order
Contractor ID Code
Checking the Indoor Blower Section
Equipment Make*
Equipment Model*
Evaporator Drain Line and Trap
Indoor Blower Direct Drive / Belt Drive
Check for Lubercation ports on motor
Motor Bearings
Blower Bearings
Motor Pulley
Blower Pulley
Fan Belt
Belt Adjust
Install a clean air filter
Fresh Air Intake
Economizer Minimum Poistiion
Economizer Change Over Setpoint
Economizer Mixed Air Set Point
Comments included Filter and Belt Size
Checking the Outdoor Equipment
Is the condenser coil clean
Is the area around the condenser clear
Clear area above the condenser
Compressor Contactor
Condenser Fan Motor Bearing
Condenser Fan Blade
Outdoor Service Disconnect
Comments
Run the AC for 5 minutes and take the following temperature readings
Temperature Reading °C or °F
Supply Air Temperature
Return Air Temperature
Suction Line Temperature Compressor
Condenser Discharge Air Temperature
Outdoor Air Temperature
Thermostat Area Temperature
Condensate Draining
Comments

 


Heating Categories

BOILERS:

Controls
Pumps
Electric Zone Valves
Pneumatic Zone Valve
Air-Vents/Purgers
Expansion Tank
Vent Damper
Thermostat

GAS FURNACE:

Thermocouple
Controls
Ignition Controller
Gas Burners
Motors
Hot Surface Ignitors
Gas Burners
Blowers
Thermostat
Draft Inducers
Valves

HEAT PUMP:
Controls
Motors
Thermostat

OIL FURNACE:

Pumps
Controls
Motors
Oil Burners
Tanks
Thermostat
Nozzles
Motors
Transformers
Flame Relays
Electrodes
Barometric Damper

Keyword searches work best with single words

Part number search only need the first 3 or 4 characters


More Information
Change of Season
Spring and fall are a challenge for your equipment to maintain comfort in the building

Need help NOW!!!
Our experienced technicians have over 20+ years in the field servings

Cracked Heat Exchanger
This is one I always hated telling the customer, "You have a cracked heat exchanger and your furnace has to be replaced,...Today."

My Furnace burner cycles on and off
There two things that normally cause burner short cycling

Oil Burner Flame Failure
Oil burners will shut down and require a manual reset.

Residential boiler maintenace
September is the time to get your boiler ready for the winter.